Unfortunately no one can be told what fun_plug is - you have to see it for yourself.
You are not logged in.
Hello folks,
Is there any way to use USB interface while Etnernet is running. That is, can we load usb module and use it. Yes i know there is a protection mecanism on the usb connector, but we can remove it. My question is linked to the firmware possibility.
Thanks.
Offline
I believe that once the box starts the Linux-based NAS, access to the NTFS partition via the USB interface gets disabled.
Conversely, one needs to plug the device into a USB port before powering up the DNS-313 if they want USB access. The firmware and Linux does not run when in USB mode - it is exclusive hardware access for the USB bridge to the SATA drive NTFS partition.
Hope this helps.
=Virgil
Offline
Well, i think the best way to test this is to trace the init at boot time. I have seen some usb support in the init scripts but i have to check this in deep.
Offline