Unfortunately no one can be told what fun_plug is - you have to see it for yourself.
You are not logged in.
After the upgrade to ALT-F RC5 my box doesn't work anymore.
I soldered the jtag header and once connected via tty i can't reach the u-boot command prompt.
I can't stop the autoboot.
I tryed almost every space +1 combination.
This is the console output
** MARVELL BOARD: DB-88F6281A-BP LE U-Boot 1.1.4 (Jan 21 2011 - 11:56:48) Marvell version: 3.4.14.DNS-320_03 U-Boot code: 00600000 -> 0067FFF0 BSS: -> 006CEE80 Soc: MV88F6281 Rev 3 (DDR2) CPU running @ 800Mhz L2 running @ 400Mhz SysClock = 200Mhz , TClock = 166Mhz DRAM CAS Latency = 3 tRP = 3 tRAS = 8 tRCD=3 DRAM CS[0] base 0x00000000 size 128MB DRAM Total size 128MB 16bit width Flash: 0 kB Addresses 8M - 0M are saved for the U-Boot usage. Mem malloc Initialization (8M - 7M): Done NAND:128 MB *** Warning - bad CRC or NAND, using default environment CPU : Marvell Feroceon (Rev 1) Streaming disabled Write allocate disabled USB 0: host mode PEX 0: interface detected no Link. Net: egiga0 [PRIME] Hit any key to stop autoboot: 0
There, i can't stop the kernel loading sequence.
and after that, what Iìll have to do?
Offline
Ok, actually I can reach the webpage of ALT- but, when I try to upgrade the firmware, It print at screen "unsupported unknown board".
But I've used this NAS with the RC4 for two years.
It's possible to FORCE the firmware through the webpage?
Thank you
Offline