DSM-G600, DNS-3xx and NSA-220 Hack Forum

Unfortunately no one can be told what fun_plug is - you have to see it for yourself.

You are not logged in.

Announcement

#1 2008-05-14 19:20:43

gnugu
Member
Registered: 2008-05-08
Posts: 27

Cannot telnet after SVN installed.

Hello,
I have followed the instructions given here http://dns323.kood.org/howto:subversion:fun_plug_native with only one exception - I have 1.04 firmware.

After the step 13 (and it was May 13! when I have done it) I now longer can telnet to my DNS. It refuses the connection.

Any ideas what might have happened?


Thank you.

Offline

 

#2 2008-05-15 20:00:49

gnugu
Member
Registered: 2008-05-08
Posts: 27

Re: Cannot telnet after SVN installed.

Ok. I can telnet now. I did nothing to remedy the problem. Somehow it started to work again.

Yesterday I changed the workgroup name and for about an hour I couldn't see new workgroup in my network. Seems similar to the telnet problem - any change I make takes some long time to be visible.

Offline

 

#3 2008-05-16 00:50:21

bq041
Member
From: USA
Registered: 2008-03-19
Posts: 709

Re: Cannot telnet after SVN installed.

That is windows.  Changing workgroups and not seeing them, or not seeing whole workgroups, or seeing them and computers sporadically has been with windows since windows was windows.


DNS-323     F/W: 1.04b84  H/W: A1  ffp: 0.5  Drives: 2X 400 GB Seagate SATA-300
DNS-323     F/W: 1.05b28  H/W: B1  ffp: 0.5  Drives: 2X 1 TB  WD SATA-300
DSM-G600   F/W: 1.02       H/W: B                Drive:  500 GB WD ATA

Offline

 

#4 2008-05-16 00:51:36

gnugu
Member
Registered: 2008-05-08
Posts: 27

Re: Cannot telnet after SVN installed.

Actually, it's Kubuntu I use. Windows too, but couldn't see it on Kubuntu as well.

Offline

 

Board footer

Powered by PunBB
© Copyright 2002–2010 PunBB