Unfortunately no one can be told what fun_plug is - you have to see it for yourself.
You are not logged in.
This is really a FYI. About a month after I purchased the 323, I added the funplug and and I started using Twonky. The 323 always remained in standby mood before I added the funplug but after I added the funplug I noticed that the large blue LED would light up, there would be disc activity and It seemed to be certain intervals but I was unsure of the timing. I went through twonky settings and found that changing the "rescan in minutes" to 0 has allowed the 323 to remain in standby until the 323 is accessed. Other than the obvious manual rescan after I add new content, is there any harm in changing this setting??
Last edited by 007james (2009-07-21 21:15:14)
Offline