Unfortunately no one can be told what fun_plug is - you have to see it for yourself.
You are not logged in.
I got this NAS like a week ago and flashed rightway with 1.10b7 formatted my w20ears hdd and then did some testing and the disk scan tool always failed on both drives no matter what configuration it failed. I didn't think to much of it and copied my data and then flashed back to 1.09. Tried again and still failed. What i did notice today under status is below and which has me worried and confused as i clearly remember seeing the correct MB amount. Is this the fault of AFT formatted drives and flashing back to 1.09?
Total Drive(s): 2
Volume Name: Volume_1
Volume Type: Standard
Total Hard Drive Capacity: -1 MB
Used Space: 0 KB
Unused Space: 0 MB
Volume Name: Volume_2
Volume Type: Standard
Total Hard Drive Capacity: -1 MB
Used Space: 0 KB
Unused Space: 0 MB
Can some one with AFT drives and 1.09 post there results pleas?
Last edited by jebise (2011-09-15 04:23:30)
Offline
oops, have to disable fun_plug before you scan.
ARG :@
since i'm on 1.09 would that not cause issues with scanning AFT formatted drives? Should i update to 1.10b7 again just to scan?
Last edited by jebise (2011-09-15 04:59:41)
Offline