Unfortunately no one can be told what fun_plug is - you have to see it for yourself.
You are not logged in.
Pages: 1
I have two HDDs installed in my DNS-323 in separate mode. Today I was using rsync to sync some files from one disk to another, and rsync reports that the transfer rate is about 5.5MB/s when transfering a large (800MB) file, which seems a bit too low.
Is it normal?
Offline
I get about 9 from NAS to NAS but not internal disk to disk. I have a gbit switch.
Offline
dickeywang wrote:
I have two HDDs installed in my DNS-323 in separate mode. Today I was using rsync to sync some files from one disk to another, and rsync reports that the transfer rate is about 5.5MB/s when transfering a large (800MB) file, which seems a bit too low.
Is it normal?
That's about what I get as well, 5.5MB/s using rsync.
As a test, I tried using robocopy from my Vista machine to copy the same set of files over. In this case I got about 4.5MB/s
Last edited by dan.crouthamel (2007-09-15 16:20:26)
Offline
dan.crouthamel wrote:
That's about what I get as well, 5.5MB/s using rsync.
As a test, I tried using robocopy from my Vista machine to copy the same set of files over. In this case I got about 4.5MB/s
Thanks for the info, now I know I did not get a defect one.
So it seems either the CPU or the system board is limiting the performance. I would say it is the CPU because the 30-50% reading speed improvement when jumbo frame is enabled.
Offline
Pages: 1