DSM-G600, DNS-3xx and NSA-220 Hack Forum

Hi,

I just bought a new DNS-313 and plugged in a Seagate 250GB drive into it (I checked it's on the supported list).

I can see the drive on USB, as soon as I plug it in it is my computer asks me if I want to initialize/format it (I am on a Macbook Pro, OSX Tiger 10.4.11). It was also tested this way at the store, when I asked them to verify that the disk would work with the DNS.

However, when I plug it into my home router (Linksys WRT54G3G) it does not seem to be getting an IP at all. The network LED glows blue (and occassionally blinks) which suggests that all is fine, but:
* I can't find the box's address through the router's DHCP table, which I can see on the router's administrative web interface -- all my other home computers are visible here, either via Wifi or via Ethernet cable
* I can't ping the box under the default address listed on the manual (192.168.0.32) either
* I can't find it via the Click'n'Connect or the Easy Search utility (I am only able to run them in Parallels virtual machine)

Any ideas what can be wrong here??

I already tried:
* a different ethernet cable. I tried resetting the box but it does not seem to reset (I insert and hold the pin in the back panel reset hole, but nothing blinks as described in the manual).
* resetting the router's DHCP addresses to 192.168.0.16-64, router is at 192.168.0.1 and mask is 255.255.255.0

I'm really out of ideas.

Tomasz