Differences
This shows you the differences between the selected revision and the current version of the page.
| howto:hardware_reset 2016/12/16 12:24 | howto:hardware_reset 2019/08/14 05:15 current | ||
|---|---|---|---|
| Line 5: | Line 5: | ||
| - Using the hardware reset button | - Using the hardware reset button | ||
| - | The hardware reset button is documented in the D-Link DNS-323 Manual ver 1.2. (ftp://ftp.dlink.se/Products/dns-products/dns-323/Documentation/DNS-323_manual_12.pdf) however does not discuss how it is used. | + | The hardware reset button is documented in the D-Link DNS-323 Manual ver 1.4. (http://files.dlink.com.au/products/DNS-323/REV_C/Manuals/v1.4/DNS-323_MANUAL_1.40.pdf) however does not discuss how it is used. |
| How-to perform a hardware reset | How-to perform a hardware reset | ||
| Line 25: | Line 25: | ||
| __Extra Note:__ for me the hardware reset is much more simple. Leave the 323 on and simply hold down the reset button for a few seconds. After a short time the square light on the front will start to flash. You can now release the reset button and you should be back to factory settings in a short while. | __Extra Note:__ for me the hardware reset is much more simple. Leave the 323 on and simply hold down the reset button for a few seconds. After a short time the square light on the front will start to flash. You can now release the reset button and you should be back to factory settings in a short while. | ||
| + | __Addition to the Extra Note:__ I can confirm that this simpler method worked for me on a DNS-323, hardware version C1 and firmware version 1.10 | ||
| ---- | ---- | ||
| - | On my version **(H/W B1)** the procedure is the following: when the NAS is on, press the reset button with a pin. Then, press the power button until it starts blinking. Then, release the reset button. This will go back to factory settings. | + | On my version **(H/W B1)** the procedure is the following: when the NAS is on, press the reset button with a pin. Then, press the power button until it starts blinking. Then, release the reset button. Then, release the power button. This will go back to factory settings. |
