Unfortunately no one can be told what fun_plug is - you have to see it for yourself.
You are not logged in.
dns-323 LAN Settings speed show 10mbps
when first setup , without any drive, the dns-323 show LAn settings speed 10mbps, even thought i connect to a dlink dir-825 with gigabit nic connection, is still show 10 mbps for link speed on the web interface LAN setting configuration page.
I confirm that the connection on the router is gigabit speed, I confirm that the cable is capable of gigabit speed,
LAN setting is set for auto
when I try to apply 1000 , it hang, then I reboot the dns-323 and check the LAN setting page, it still show 10 mbps for speed, but for link speed the 1000 is selected
I already try the latest firmware, even try a third party firmware, now back with the dlink firmware , still same 10 mbps
Offline
Try another cable then try another router or switch - in most cases, when a gigabit capable device does not connect at gigabit speeds, the problem is a defective cable, however, it is also possible to have autonegotiation problems.
I would suggest you not try to force 1000 mbs from the NAS' web interface - even if you succeed, you run the risk of being unable to communicate with the NAS, and the only way back is a reset to defaults.
Offline