DSM-G600, DNS-3xx and NSA-220 Hack Forum

rap · 2008-03-21 10:20:27

Hi

I'm trying to get transmission & clutch working as per the instructions in this forum.

I have transmission running and have the lighttp (1.4.18) and php (525) running (php -m shows that this is the correct version with json and sockets compiled)

I've used the lighttpd.conf with the php support and enabled the right lines (at least I think I have and the syntax check as described on the wiki passes)

There are no errors being written to the error log yet every time I try and access the web page I get a "400 - Bad Page" error.

Anyone have any more tips or ways to troubleshoot this?

TIA

RAP

moquilok · 2008-03-21 11:16:39

Have you been able to get any page to load with lighttpd or is the problem only with clutch not loading?

rap · 2008-03-21 12:05:41

moquilok wrote:
Have you been able to get any page to load with lighttpd or is the problem only with clutch not loading?

I can't get anything to load - I created a test folder and placed a simple html file in there but trying to load that gives the same 400 error

RAP

rap · 2008-03-22 09:26:27

I've got to the bottom of this after a bit of searching.

I had named my DNS "XXX_Dlink" and lighttpd does not accept underscores in the host name !!

RAP

KyleK · 2008-03-23 04:12:22

Wow, glad you figured this one out. I would never have guessed that cause in a million years

DSM-G600, DNS-3xx and NSA-220 Hack Forum

Announcement

#1 2008-03-21 10:20:27

Problem with lighttpd (trying to set up transmission and clutch)

#2 2008-03-21 11:16:39

Re: Problem with lighttpd (trying to set up transmission and clutch)

#3 2008-03-21 12:05:41

Re: Problem with lighttpd (trying to set up transmission and clutch)

moquilok wrote:

#4 2008-03-22 09:26:27

Re: Problem with lighttpd (trying to set up transmission and clutch)

#5 2008-03-23 04:12:22

Re: Problem with lighttpd (trying to set up transmission and clutch)

Board footer