Unfortunately no one can be told what fun_plug is - you have to see it for yourself.
You are not logged in.
Since some weeks I have the DNS-323 with two Samsung 500gb in RAID0 running without any problems whatsoever, except for a mapping issue.
But unfortunetaly since yesterday the device is not visable nor accessible anymore. Easy Search 3.4.0 is not able to find the device either, I can see the activity led blinking but nothing more then that.
I even tried to put in two Maxtor 250gb's but without any succes.
Does anyone have an idea how to solve this? Or do you think the DNS-323 is broken?
Offline
Have you tried the basic stuff - like rebooting it?
Offline
did u unplug the unit 4 maaybe 2 mins the plug back in that should reset the onboard circuitry. ive had it happen 2 me on a few ocassions. (5)
that lways does it 4 me
Offline
Thanks guys, I just found a little reset button at the back of the device and that did the trick!!! Everything is still there!!
Offline
hello,
iīve the same problem. after resetting the device to factory defaults (with FW 1.02b) i cant find my DNS-323 with the old ip, with the standard ip and with the easy search utiliy 3.4.0.0 from dlink. all the leds are on.
can u tell me how to use the reset button? only klick when the device is on. or hold down until start????
thx..
Offline
Hi,
I switch the device off, pulled out my two hd's and switched the device on again. Then I pushed the reset button for about 10 seconds and released it.
This worked for me and hope that it will work for you as well!
Offline
Hi back,
thanks a lot!
it worked fine, but only with my computer connected over a crosslink cable. in my homenetwork with dhcp server in the dsl router i didnīt get a connection.
now i reinstall the hole system because i belive only updating the firmware didnīt solve all my problems....
...
Offline