DSM-G600, DNS-3xx and NSA-220 Hack Forum
Unfortunately no one can be told what fun_plug is - you have to see it for yourself.
You are not logged in.
Announcement
IRC Channel #funplug on irc.freenode.org
#1 2008-06-14 04:26:44
- rx2
- Member
- Registered: 2008-06-08
- Posts: 18
Setting an environment variable on login
Hi,
I have a very simple and newbie question.
I am running ffp and have just installed transmission.
I want to set an environment variable automatically when I start my telnet session so that I am able to use tranmission-remote. Anyone know how to do this automatically?
The variable I need to set is :
export TRANSMISSION_HOME=/mnt/HD_a2/.transmission
How do I this?
Thanks
Robert
Last edited by rx2 (2008-06-14 04:49:00)
Offline
#2 2008-06-14 11:43:05
- SilentException
- Member
- From: Island of Krk, Croatia
- Registered: 2008-05-04
- Posts: 148
Re: Setting an environment variable on login
it wouldn't hurt to search for a bit but here it goes 
i guess you're using ffp0.5? if so, add the "export..." line to /ffp/etc/profile and fun_plug
D-Link DNS-323 v1.05 fun_plug-ed + many mods, 2 x 320GB Seagate Barracuda 7200.10 RAID0, Cat6 Gigabit Network, 9k Jumbo Frames, Average (WRITE): 19,32 MB/sec, Average (READ): 28,6 MB/sec
Offline
#3 2008-06-15 06:43:40
- rx2
- Member
- Registered: 2008-06-08
- Posts: 18
Re: Setting an environment variable on login
Thanks SilentException...
I did find that you can do it through ssh etc/profile but couldnt find anything for Telnet through my searching - I couldnt of looked hard enough :-)
Once again thanks again...
Offline