DSM-G600, DNS-3xx and NSA-220 Hack Forum

Bizarre. No answers here, but I notice that when I run e2fsck using the FFP fsck method that my right drive blinks for some 5 minutes or so before they both start going. I find this really odd since I'm running RAID-0... Hope you figure this out!

I have the same problem. When I received my DNS-323 three weeks ago I set up everything it worked without any problem. The hardrives were set into hibernation mode after the time specified time in the settings. For a few days the right HD keeps blinking all the time and the system won't hibernate.

I'm using Firmware Version: 1.06 without any modifications.

Any new ideas how to solve the problem?

_______________________________________

HARD DRIVE INFO :
Total Drive(s):     2

Volume Name:     Volume_1
Volume Type:     RAID 1
Sync Time Remaining:     Completed
Total Hard Drive Capacity:     490402 MB
Used Space:     317484 MB
Unused Space:     172917 MB

Volume Name:     Volume_2
Volume Type:     JBOD
Total Hard Drive Capacity:     493851 MB
Used Space:     24 KB
Unused Space:     493851 MB

PHYSICAL DISK INFO :
Slot    Vendor    Model    Serial Number    Size
1    SAMSUNG    HD501LJ    S0MUJ1CQ300532     500 G   
2    WDC    WD10EACS-00D6B1    WD-WCAU46163241    1000 G

I have exactly the same issue with the right drive. The drive is clicking away at a regular rate. If I reboot the dns-323 then all seems fine but after writing to the drive (or maybe just using it at all) the right LED keeps on blinking. The first time this happened it did it for about 24 hours and I thought it was normal. But then it kept going for days before the unit seemed to hang and I rebooted.

Has anyone found a reason / explanation / solution? I don't mind too much that the drive is getting worn out by not hibernating as long as I know that the data is writing to both (RAID 1) alright and one of the drives isn't broken.

Thanks,
Alex