DSM-G600, DNS-3xx and NSA-220 Hack Forum

gegtik · 2009-10-25 00:22:27

So after some mucking around now I find my samba conf is backwards which is really irritating. I've tried to telnet in and change the config but it's always reset after a reboot to the same crossed-up setup.

how do i fix this?

bjby · 2009-10-25 00:50:55

Put your changes into the funplug script to make them survive reboot.

http://www.jordandelozier.com/2009/04/e … -settings/

Last edited by bjby (2009-10-25 00:56:40)

newbie2 · 2009-10-25 07:43:35

Not sure this is your issue. But when this happened to me I just need to ...
1. power off device. eject both drives.
2. insert drive you want to be volume_1 and power up unit. after dns is up and running (aka you can see web page,it will show the drive as volume_1) ... power off device.
3. insert 2nd drive and power up dns again.

your drive order will now be swapped. At least this worked for me in the past.
Regards
Newbie2

Last edited by newbie2 (2009-10-25 07:45:00)

gegtik · 2009-10-26 03:48:02

newbie2 wrote:
Not sure this is your issue. But when this happened to me I just need to ...
1. power off device. eject both drives.
2. insert drive you want to be volume_1 and power up unit. after dns is up and running (aka you can see web page,it will show the drive as volume_1) ... power off device.
3. insert 2nd drive and power up dns again.

your drive order will now be swapped. At least this worked for me in the past.
Regards
Newbie2

This was *exactly* what I needed -- thank you so much!

DSM-G600, DNS-3xx and NSA-220 Hack Forum

Announcement

#1 2009-10-25 00:22:27

Volume_1 mapped to HD_b2, Volume_2 mapped to HD_a2???

#2 2009-10-25 00:50:55

Re: Volume_1 mapped to HD_b2, Volume_2 mapped to HD_a2???

#3 2009-10-25 07:43:35

Re: Volume_1 mapped to HD_b2, Volume_2 mapped to HD_a2???

#4 2009-10-26 03:48:02

Re: Volume_1 mapped to HD_b2, Volume_2 mapped to HD_a2???

newbie2 wrote:

Board footer