Unfortunately no one can be told what fun_plug is - you have to see it for yourself.
You are not logged in.
Here is my configuration: DNS-313 revA1. Last week, I installed transmission, and it went wrong: after rebooting, the device LED goes to green whatever I tried to do...
So, I decided to delete all partitions, hard-erase every data on my DD, and start from fresh, with DCC connect.... but that doesn't solve the problem either: the installation process seems to be OK, until it asks to restart.... and at that point: nothing! the device stays on, with the green light.
Then, I go back to USB, and here is the surprise: nothing was done! The partitions have not been created, the whole disk is unallocated! it's like the whole process was doing nothing at all
I can't figure what is the problem: for the moment, I can only access it through USB, all other functions seems dead
Anyone has any idea ?
Last edited by L1 (2012-01-23 22:40:07)
Offline
Ok, I've been trying to get my box back on its feet this WE with no luck: the disk is in good shape, the USB functions are correct... I'm suspecting that somehow, the flash memory got corrupted (is this possible? maybe because of a power disconnection?).
I'd like to try one last thing (before transforming my DNS-313 into a noisy external USB drive): format the hard drive exactly as DCC would have done it, and copy the system in the partition as Dlink had planned.
But I don't know what size and format I should give those partitions, nor how tounpack those files. does anybody have information on this ?
Offline
I can try to help. What information do you need?
This is the partition table, on my 1 TB Seagate drive:
(note: I've increase partition /dev/sdv4)
sudo fdisk /dev/sdb Command (m for help): p Disk /dev/sdb: 1000.2 GB, 1000204886016 bytes 255 heads, 63 sectors/track, 121601 cylinders, total 1953525168 sectors Units = sectors of 1 * 512 = 512 bytes Sector size (logical/physical): 512 bytes / 512 bytes I/O size (minimum/optimal): 512 bytes / 512 bytes Disk identifier: 0x000e1740 Device Boot Start End Blocks Id System /dev/sdb1 63 1012094 506016 82 Linux swap / Solaris /dev/sdb2 6088635 1953520064 973715715 7 HPFS/NTFS/exFAT /dev/sdb3 * 1012095 2024189 506047+ 83 Linux /dev/sdb4 2024190 6088634 2032222+ 83 Linux Partition table entries are not in disk order
I can create a tar.gz from /dev/sdb3, if you think it can be useful.
Maybe you can try to build a serial cable, in order to see what's going wrong during the boot process.
Offline