DSM-G600, DNS-3xx and NSA-220 Hack Forum

I connected with serial and i get the following on boot :



Marvell>>  ** LOADER **
** MARVELL BOARD: RD-88F5182-NAS-2 LE

U-Boot 1.1.1 (Feb 26 2009 - 11:33:03) Marvell version: 1.7.3.003

DRAM CS[0] base 0x00000000   size  64MB
DRAM Total size  64MB
Detect phy 1118
[8192kB@ff800000] Flash:  8 MB
Addresses 20M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (20M - 16M): Done
*** Warning - bad CRC, using default environment


Soc: MV88F5182 Rev 2
CPU: ARM926 (Rev 0) running @ 500Mhz
SysClock = 166Mhz , TClock = 166Mhz


USB 0: host mode
USB 1: host mode
PCI 0: PCI Express Root Complex Interface
PCI 1: Conventional PCI, speed = 33000000
Hit any key to stop autoboot:  0
## Booting image at ff820000 ...
   Image Name:   Linux-2.6.12.6-arm1
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    1490204 Bytes =  1.4 MB
   Load Address: 00008000
   Entry Point:  00008000
   Verifying Checksum ... Bad Data CRC
Marvell>>




any ideas on how i can fix this ?