Unfortunately no one can be told what fun_plug is - you have to see it for yourself.
You are not logged in.
I can get the funplug to start up with a single hard drive. The issue occurs if I connect two as single volumes. the funplug script will not load up. Does anyone know what I am doing wrong? Thanks.
Offline
Nevermind. After fiddling around, I found out that if you have two volumes, it will try to load the funplug from the 2nd drive.
Offline
Well for me, the fun plug will only load on the hard drive to the right side (Volume_2). It does nothing for the hard drive on the left (Volume_1). This is of course when I have two hard drives plugged in.
When I only have 1 hard drive in, it loads off the first hard drive. Is it not supposed to act like that?
Offline
Don't know why, but my teammate at work gave me the tip to install my first ( at the moment my only drive) into the right bay.
He also told something about getting problemes with fun_plug
if I install the first drive in the left bay and put anonther drive in the second slot later.
Unfortunately I didn't ask him about the backgrounds.
I don't have read the installation instructions till know. I've only seen that the left slot is labeled with HDD1.
Perhaps the right slot is labeled with HDD0 -> Volume 1 ?
Last edited by spflug (2007-07-23 12:40:54)
Offline
sfplug - That's exactly the problem I had run into.
I installed my first drive into the left bay (volume_1) and installed the fun plug without any problems. When I installed my second drive (volume_2 right side) after, my telnet was not booting up. I tried redoing the funplug with the tar file into the root Vol1 drive. It didn't extract or anything so I knew it wasn't loading it up. After sticking it into Volume two, the files were extracting correctly and telnet was working fine again for me.
And for me the left slot is labeled Volume_1 while the right slot is labeled Volume_2.
Last edited by xmemphistox (2007-07-23 12:55:51)
Offline
Yes, came around reading the manual.
Found this at DNS323.info ( look at the two white slots):
http://dns323.kood.org/_detail/11.jpg?i … ache=cache
http://dns323.kood.org/_detail/9.jpg?id … ache=cache
The right slot is for the first drive ( HDD0) and the left slot for the second drive ( HDD1).
But I don't know what happen to the Data when changing the drives from left to right !??
Last edited by spflug (2007-07-23 13:23:34)
Offline
