Unfortunately no one can be told what fun_plug is - you have to see it for yourself.
You are not logged in.
Hi,
after upgrading to fw 1.06 and funplug 0.5 I enabled ssh.
Ssh login works, but takes literaly ages to get me to the command line.
It takes about 5-10 seconds until the "Login as:" prompt comes up.
Once the username is entered it takes a good half minute until the password-requests becomes display.
After that the login goes through and normal response times can be seen.
Client is putty, btw.
Is that normal?
Cheers,
Emacs
Last edited by Emacs (2009-01-16 08:40:29)
Offline
Check if dns resolving is working properly on the dns-323. Can it reverse resolve your IP? If not maybe you should add a host entry in /etc/hosts.
I.e
# nslookup x.x.x.x
Last edited by frodo (2009-01-16 16:21:52)
Offline
Adding a line to the /etc/hosts on the DNS323 did the trick (resolving the ip address of the accessing client PC).
But I guess, that's not a permanent change and a reboot will reset the /etc/hosts.
Right?
Cheers,
Emacs
Offline
Emacs wrote:
But I guess, that's not a permanent change and a reboot will reset the /etc/hosts.
Right?
See http://dns323.kood.org/forum/t1971-Chan … eboot.html for ways to auto add the values.
Offline